FABRICATION OF HALF WING AEROFOIL SHAPED FUSELAGE UAV MODEL AND INVESTIGATION OF IT'S POINT SURFACE PRESSURE ON WING SURFACES

  • Wg Cdr G.M. lahangir Alam MIST
  • Md Mamun
  • Md. Abu. Taher Ali
  • Md. Quamrullslam
  • A.K.M. Sadrullslam
DOI: https://doi.org/10.47981/j.mijst.02(02)2013.92(%25p)
Keywords: HALF WING AEROFOIL SHAPED FUSELAGE UAV MODEL

Abstract

FABRICATION OF HALF WING AEROFOIL SHAPED FUSELAGE UAV MODEL AND INVESTIGATION OF IT'S POINT SURFACE PRESSURE ON WING SURFACES

Downloads

Download data is not yet available.

References

NA
Vol. 2(2), 2013: MIST Journal of Science and Technology
Published
2019-12-15
How to Cite
Wg Cdr G.M. lahangir Alam, Md Mamun, Md. Abu. Taher Ali, Md. Quamrullslam, & A.K.M. Sadrullslam. (2019). FABRICATION OF HALF WING AEROFOIL SHAPED FUSELAGE UAV MODEL AND INVESTIGATION OF IT’S POINT SURFACE PRESSURE ON WING SURFACES. MIST INTERNATIONAL JOURNAL OF SCIENCE AND TECHNOLOGY, 2(2). https://doi.org/10.47981/j.mijst.02(02)2013.92(%p)
Issue
Vol 2 No 2 (2013): MIST Journal of Science and Technology
Section
ARTICLES

Though MIJST follows the open access policy, the journal holds the copyright of each published items.

Creative Commons License
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.